A、使用方法：將注塑機溫度調高 10 度至 20 度把適量的清潔粉混合在塑料中（如轉用塑 料，可混合將要使用的塑料），混合后將材料放入料斗中，先將馬達速度調慢，把混合料 壓出至模頭，待見到混合料后再把馬達速度調快少許，然后每隔 2 分鐘進行注塑。
B、用量8 安機：80-100 克清潔粉/2-4公斤塑料，24 安機：150-200克清潔粉/4-6公斤塑 料，原料成份不同，以上份量亦按不同需要而定。可先加入少許白礦油以防止清潔粉四散。 因每種色粉及。
C、注意：如不慎把清潔粉沾入眼中，請用大量清水沖洗警 告：使用前作小樣測試而作出肯定。內含壓力氣體，勿讓兒童玩耍，勿近火源使 用，勿擠壓與碰撞，不可曝曬或燃燒，存放在 40℃ 以下陰涼、通風乾燥處。
A, the use of methods: injection molding machine temperature increase 10 degrees to 20 degrees to the right amount of cleaning powder mixed in plastics (such as the conversion of plastic, can be mixed to use plastic), after mixing the material into the hopper, the motor speed is slow, the mixture out to die, to see the mixture after the motor speed up a little, then every 2 minutes for injection.
B, dosage 8 An machine: 80-100 grams of clean powder /2-4 kg of plastic, 24 An machine: 150-200 grams of clean powder /4-6 kg of plastic, raw materials are different, the above amount is also determined by different needs. Can add a little white mineral oil to prevent cleaning powder scattered. Because each kind of toner and.
C, note: if carelessly clean powder dipped into the eyes, please rinse with plenty of water. Warning: to make sure the sample test before use. Containing gas under pressure, do not let the child play, not near the fire source, do not squeeze and collision, not exposure or burning, stored in 40 DEG C cool, ventilated and dry place.

查看全部介紹